Pulse Suppressors

/Pulse Suppressors
Pulse Suppressors 2017-05-09T16:23:06+00:00
Pulse Suppressor

Pulse Suppressor

Why Use a Pulse Suppressor?
A pulse suppressor, also known as a dead zone eliminator, is used in conjunction with an OTDR to occupy the dead zone. This helps provide accurate test results in areas where loss must be calculated. A pulse suppressor consists of a length of SM or MM fiber between 300m and 2.2m in length, the fiber is coiled up in a case that has two patch cords extending from the case to connect to the input and output of the fiber.

Adding a length of fiber before the initial connection will not eliminate the dead zone, it will simply move it out. Because a dead zone cannot actually be eliminated, a pulse suppressor is used to identify the quality of the first connector within a fiber span. A launch cord creates linear backscatter before the first connector.

Pulse_Supressor_Chart

What About the Far End Connector?
A pulse suppressor can also be used at the and of the fiber to verify the quality of the end connection. The backscattered signal can now be measured on both sides of the connectors, allowing for loss and reflectance measurements of the front and far end.

An OTDR is used to help identify all the characteristics of the fiber including splices, connectors and the quality of the fiber itself, however pulse suppressors were required to really test the quality of the front and far end connectors.

Advantages:
• Identifies quality of front end and far end connectors
• Improves EMD in Multi-Mode fibers for more precise measurements
• Helps identify good launch levels from an OTDR using a good known lead-in fiber

Far_End

PRO Pulse Suppressors are built to order and are available in any configuration you require. When ordering, simply follow the chart below to create your product part number.

Pulse_Supressor_Configurator

Downloads
Pulse Suppressor Product Spec Sheet